A sharp abrasive noise when disengaging is often due to a worn release bearing. To fix this, you need to remove the engine, so it is advisable to thoroughly check the pressure plate and clutch disc or even better to replace them directly.

The release bearing is mounted on the clutch fork with clamps.

Use only the special clutch assembly grease for proper and long-lasting lubrication of the release bearing, primary shaft, thrust bearing, and possibly installed guide bushing. Normal grease can melt due to heat and end up on the clutch disc.

Suitable for:

Beetle 1300 1302 1303 8.1970 and later

Beetle 1200 1972 (VIN 112 2670 583) and later

Karmann Ghia 8.1970 and later

Bus 8.1970 and later

Type 3 8.1970 and later

Kübel 8.1971 and later